Separate names with a comma.
Most likely to be the cheap OEM Brembo master. I am on my second one, the first admitting air all the time and never getting a good solid lever...
(See a long thread on here by @Daddy2coull regarding his Hyper. He was man-enough to admit that the whole thing was his mistake. I think most...
If not in neutral, the wheel will rotate a few degrees each way as it takes up the slack between the dogs in the gearbox. It it's solid, it's...
Are you using a 60 or 70 on the front?
Try loosening the rear spindle nut and see if it frees off the wheel.
Don't understand. Are you saying that with the bike on a stand and in neutral with the engine switched off the back wheel will not rotate? It...
Are you at Imola? Go and say 'Hi' to my friend Neil on the Lucky Strike Gixer!
If only we still had tax discs. I miss those "where shall I put my tax disk on my <enter-bike-model-here>?" posts!
Liar! That chain has never been used! :-)
Git!
I have heard that he's replacing VR46 at Yamaha... (dives for cover...)
Press the indicator cancel button to initiate a mode change. Press it again until the required mode is selected. Press and hold to change the...
Chrome works well. I agree about Safari, it's rubbish. Can't do internet banking with it, can do so with Chrome. My bike's tracker web site...
...on Saturday morning was chaos. Big queue to passport control, then another big queue to the ferry check-in. I lost count of the number of...
Was the lockup instantaneous or did it the bike decelerate a bit first? I think it is unlikely to be anything within the engine itself....
It is not sitting nicely because the nut isn't aligned with the hole. The angle is causing the rest of the clip to be pushed away from the groove...
Agree. The pin is supposed to go through one of the holes in the axle to prevent the nut from undoing. it cannot do it's job otherwise. if it...
You'd best head into the Vercours tomorrow, then!
Most old fashioned bikes with cables had some free play at the grip and it wasn't much of an issue. I don't understand what all the fuss is about...
Go Pete, go! :-)
