Separate names with a comma.
Same here as I have one BT Internet email address from when I was with them but I have never used it fortunately as I suspected something might go...
It is true they are not that robust comparatively and the nearside main bearing is an issue with a lot of 998/999 models, but other models in the...
That's why I left BT, totally useless and expensive. When I told them I was leaving them they fell backwards over themselves to give me various...
You could try Bikenders they break Ducati's and a few people on the forum in the past have got the odd engine from them.
All mono subframes are aluminium and all biposto subframes are steel in order to take the weight of two people. If you cannot see what material...
my 998 uses the same fixings for the mirror bolt as the fairing screen bolts, normally they are just a small phillips screw. So if you can't get...
I've had a slave cylinder come loose and that totally locked the lever, that was an Oberon slave. The bolts had worked loose and one had fallen...
Yes!! regarding the undertray, see my post on this.
Silkolene has been mentioned on this forum several times and it seems that oil consumption often increases when using it. I too have used...
Did you set the correct air gap on the ignition pickup sensor, that was diagnosed as a problem for me when I had a similar problem with my 998.
Usually if the main bearing goes the vibration cracks the side casing and that is what causes the oil leak. I have had one go on a 748R engine...
The plugs normally get torn off in an accident, you can buy new plugs on an aftermarket basis I think I have seen them for about £29. If you are...
Are you sure it's not the main bearing? these go fairly regularly unfortunately, but if it is the sprocket bearing both will require an engine...
999 Uses CAN wiring I believe so it is totally different to a 998. The 998 loom is a one off and not like any of the other 748-9*6 looms.
Your gearing must be low, I think, as at 10,000 rpm I am doing 125 mph on a 748R, seems a little strange as I have lower gearing than standard
Hmmm this has me wondering that all those years ago I got the undertray sent to me, which was meant to be a monoposto one and I wanted to fit it...
OK got it now, yes you are right, although my mono undertray had the same mounting points as a biposto, I just had to trim a few bits off, so it...
I can confirm that's the way the subframe should fit and that's what I had in my mind, no doubt the subframe shown was from a P8 ECU'd bike...
The stock 998 biposto subframe is the same as a 996 it even has the mountings for the 996 ECU despite the 998 ECU being mounted by the battery, a...
9,000 to 9,500 is a good indicator to keep engine life up and overevving does not help as it can drastically shorten engine life, there is no use...
