Separate names with a comma.
I had an intermittent front cylinder cut-out on my Monster front cylinder. Mostly it would be OK but occasionally it would cut out and run on just...
That's the one I thought you meant but still the Dremel, being careful not to go through into the tube - don't need to get all the way through the...
Mask the tube with tape, it'll be fine for blasting/coating. I certainly wouldn't remove it unless absolutely necessary as it'll be tricky and may...
Carefully cut it on both sides with a Dremel or similar and then 'crack' it off. As for the tube, I'd leave it in place but if you must remove it...
I ran my 916 with only 4 springs for years with no slippage problems. I have a larger slave cylinder fitted to both of my bikes which are fine and...
That is exactly how the '98 Biposto was but with Showa suspension all round.
As said, looks to be in good condition which, to me would be more important than whether it has new belts etc. - as I'd do a full service...
Depends on the model. Single-phase bikes; 916 & early 748 have a different flywheel to 3 phase; 996 etc. but, as above Mike Shannon makes them....
I bought my 916 new and it has now done just a few miles short of 50k.
When servicing/changing fuel filter etc. I would always check the TPS setting as it can make a big difference to the running if out of tune. I...
I had the original for years but when it failed I then went through a series of replacements that all did the same, I think it was 4 or 5 with one...
