Separate names with a comma.
Unplug the jukebox? [IMG] A well known authority on MOTs...
You can have more than 2 to an email. I've set it up for 7 vehicles (3 bikes & 4 cars) to the same email...
Part no. 19010231A http://www.forza-moto.com/en/p/2013+ducati-kit-4-x-driven-plate-th-1-5-for-race-clutch...
I got some from a French ebay seller, can't remember who though. Ducati make/made them but local Ducati dealer said they couldn't order them? I...
If you can locate some 1.5mm plain plates, then some careful swapping with 2mm plates you can get the stack height you want.
So a bit under 38mm stack height... ;)
They'd never take me alive anyway... ;)
I wonder if the VAT (or whatever it's called over there) was ever paid? (was it ever sold?) because if it was then surely that's good enough? You...
Do they even check the mileage? I imported a Moto Guzzi from Italy 3 years ago. It had done less than 12,000 miles, I filled in the NOVA...
Fit a speedo with more km showing...
It's a 2003, so a 'used' bike - there shouldn't be any VAT on import...
Been serviced recently? start with the basics all set correctly, including TPS, throttle balance & CO.
Indeed but he also said; So I wasn't sure and had heard the 748 heads were slightly different. IIRC the valves may also be seated less deeply?
I recall reading/hearing that 748 heads, whilst the same casting, have a smaller combustion chamber than 916? Not sure if you're using these or...
I suspect this to be the case. How much pushrod sticks out of the case?
As per Oberon's fitting instructions; *Included in the kit is an extension rod (pre 2000 Ducati models), and should be fitted ONLY if the...
Could it be to do with the long/short pushrod issue? Basically older bikes use a 10mm shorter pushrod than later bikes and so if using a new...
Well the genuine Ducati belts are half the cost of a £300 service... :eek:
That's cheap as you're looking at £200 of parts, not including any valve shims.
Rust aside, the basket looks OK with not much wear. With the engine off and clutch lever pulled fully in, will the clutch spin freely by hand?...
