Separate names with a comma.
Is that your actual cable or just a stock image? Asking because obviously the cable needs making to the correct length and running through the...
The whole assembly or just the cable? Because if just the cable, it would be easy enough to make it.
Looking good! :upyeah:
Wait until Machine Mart do a VAT free offer (regularly) and you can get the 'CML3' Air version for less than the manual one at normal price. Well...
The Clarke ramp has a 1" thick solid steel bar that you can push through in 1 of 2 heights to lock it in place. Not only prevents it dropping but...
I would think one is for the fork clamp bolts and the other for the yoke/tube clamp bolt? not sure which is which though? However +/- 1nm...
I believe they refer to top yoke as 'steering head bolt', in which case 23nm. 'Fork end bolt' that you've highlighted is, I believe, the axle...
I've got a Clarke lift/platform, the one with air powered lift as well as the footpedal because it's bloody tedious lifting a bike from ground to...
Roadside break; [IMG]
I've always used copper until I recently bought a Moto Guzzi and noticed they were all aluminium on that. I bought some aluminium washers to use...
Won't have made any difference. And even if it had, they'll be slightly softer which is probably a good thing as they're too hard for most riders...
I had the same happen on a KTM, the water pump housing had corroded through and the coolant gone into the crankcase. May not be the case here but...
And the rest, however there never was a recall even back when they were new and popping cush drives...
Contact Total Seal; http://www.totalseal.com/ for piston rings, they will undoubtedly have some that fit and for less than the Ducati parts.
I'd advise sticking to a 15t front and going +3 on the rear. There's a lot of chain tension from that power output and it's increased by using a...
