Separate names with a comma.
I did the same and found out the hard way. The old gaskets were 0.4mm base with a thick paper head gasket where the new gasket set uses a 1mm base...
On the old Monster/SS engines the movable pulley has two standard bearings on it and they are easily & cheaply replaceable - IIRC they are...
I've got agreed value for my bikes, whether they would actually pay out the agreed value unconditionally I'm not sure, fortunately not had to find...
Quite possibly but I have completely emptied my 916 engine of both oil and coolant (engine was apart and so known to be absolutely empty) and yet...
Just go for no. 1, why not?
Thus making it more original, as I think that's what Ducati did... :D
If nobody (including Ducati) knows, then does it matter?
All my bikes are modified to some extent. I don't worry about originality, I modify them to suit me which is to make them perform/ride/turn/stop...
I'm sure it would work fine but just keep an eye on the condition, you don't want the bike ingesting bits of it if it starts to break down or come...
I fitted the thicker seal to mine at the same time as fitting a thicker (EVR) airbox. This makes the tank difficult to fit as everything is very...
Spindle for 1098 should be the same as 848, AFAIK other than the Ohlins versions they used the same forks and wheel. As for calipers, as long as...
Indeed, the red reinforcement cord is glass fibre, kevlar is yellow. AFAIK belts don't generally 'break', rather the rubber deteriorates causing...
It is generally considered best practice to increase the rear rather than decrease the front for several reasons, however it is...
Whilst increasing teeth helps with acceleration, it helps more with rideability IMO, I doubt the actual figures, 0-100 or whatever would vary much...
There is a serrated type of washer but it is a 'long' nut and needs to be ferkin' tight so shouldn't be coming undone and definitely not because...
Exactly this happened to mine. Many years back I had the clutch replaced by a dealer as part of an insurance repair. First ride out the clutch...
When fitting car tyres they replace them but they're push-in, cheap and considered disposable. I've never heard of replacing bike valves unless...
Any reason why you're fitting new valve stems?
To calculate the actual torque you applied see; Torque Wrench Extension Calculator Basically; M1 = M2 x L1 / L2 Where: M1 is the torque...
It broke because the bolts will be tightened to more than 38nm due to the longer leverage of using it straight where a setting of 38nm will...
