Separate names with a comma.
I've only ever had this setup on the bike so can't compare before/after but I get the same amount of separation/movement of the plates (around 2.5...
I have an RCS16 with Oberon slave on the Monster, works fine with a nice smooth & light action on either setting (16/18 or 16/20). I have it on...
Lower the ride height, might affect handling a little but hopefully not too much if done at both ends?
The footpegs, both rider and pillion were clear anodised on my 916. AFAIK they were all the same...
HID works very well in a 916 dip headlight as it keeps the same cut-off and beam pattern but is so much brighter. I fitted a HID dip beam and a...
4.5% is a good number. I set the 916 to around that figure (difficult to get an exact reading) and it ran nicely. I then had it custom mapped by...
You are right, I was comparing a Motobatt to lead-acid Yuasa batteries, I've not tried a Yuasa AGM battery so can't comment on them.
I had 3 Yuasas on my 916, they all required a trickle charge if left more than a couple of weeks and none lasted very long. I've now got a...
Probably claim for weight reduction... ;)
Just make sure that if the compression tester needs an adaptor to fit the sparkplug hole that it is nice and tight on the tester as you don't want...
Nice, if you like that sort of thing. Chain looks very close to the exhaust though...
I've got a set of used 916 belts with 2 years & 5-6k miles of use on them hanging in my workshop that have more writing on than those...
I often wonder when there are discussions over the correct/exact belt frequencies just how critical it really is? given that, after a couple of...
That seems an unnecessarily complex way of tensioning a belt. Whatever was wrong with the 'old' way?
Yes but it was done as part of an engine tune; gasflowed heads which were also skimmed 1mm - the skim moving the head closer to the engine which...
Never marked belts, as said if it lines up with (or even close to) the dots then it can't be wrong. As for the vertical cylinder cam holder tool...
Agreed, for small 'project' jobs TIG is better IMO. Much neater job can be done, obviously not as fast as MIG in a 'production' environment but...
Pretty sure they were the numbers on mine, I'm thinking the one measurement is the fitting and the other the hose size? But worth checking, the...
Nice one, good to see I'm not the only one who can resist anything, except temptation... :upyeah:
Be careful what you wish for, I started down the brake upgrade route with 'just' a radial master cylinder but then got a little carried away;...
