Separate names with a comma.
That's certainly seen better days! Hopefully, that's the culprit and you get the bike back to how it should be :)
Yes Perry. It’s my workshop. Give us a shout and I’ll help where I can. We’re already taking quite a lot of bookings so bear that in mind so we...
There is no recall on the rear brake as such. There is a technical bulletin that addresses the issue of the rear brake requiring regular bleeding....
The amplifiers mount on the side of the P8 and will have their own connectors off the loom. They’re like hens teeth, so you’ll need to do some...
Short answer is no. As well as the power modules, the SPS runs a rpm sensor and a crank position sensor. The 996 uses only one to do both...
No. There’s oil fed into that shaft to help supply the clutch. There’s a seal arrangement behind the slave. Providing it’s not leaking with the...
I use the same type of balancer I bought from Abba years ago. They did their own adapter which I still use also. It’s a simple bar with two nylon...
Too tight can lead to wear issues in the final drive, but more troublesome, failure of the out put shaft bearing or even bending of the output...
If you need anything in the meantime, I’m only up the M1 at Sutton in Ashfield
Only one I know of for sure, at the moment, is that Mark is going to be there as Manager again.
My error, sorry. The antenna on the HYM is part of the ignition lock itself, not a separate item like other models. Not such an easy check.......
Try the simple things first.. does it do it on all keys? If not, could be the transponder in a particular key. Fit a new antenna. They're not that...
Thank you! It's been utter madness at times, but we've tried to keep everyone happy :)
It’s a motor group from the West Midlands, Startin motor group.
It doesn’t look right when fitted, and yes, the pressure feed is from the bushing side. The high pressure oil feed is into the oil channel in the...
Your local dealer is your best bet
IIRC, the spring faces towards the crank, away from the bushing.
8 is a bushing, 9 is a seal. A blind bearing puller is probably going to be easiest. The seal isn't too difficult, the bushing can be... warm the...
Looks like are you missing or have removed the plastic "plate" that screws under the bottom yoke? It's that that should push the flaps down. They...
No, it’s not a bad problem to have, but it’s took some managing this one has
