Separate names with a comma.
There’s no switch as such in the tank. If you can here something, then it could be the pump stalled and trying to turn? Trying another tank with...
Healtech are pretty good. Use one on my Scrambler. If the op was staying with road shift, I’d use one. For race shift, the HM is a one fit solution.
For race shift pattern, the HM shifter takes some beating. Direct mount on to gearbox shaft, sensor built in to the lever. Simple and reliable.
If it helps. Pm me his vin and I’ll check for him.
There has been a technical recall for this. Worth checking with a dealer to see if its applicable and/or has been done. It’ll save the cost of new...
I've used Bendix MF pads for several years now and they've done pretty much everything asked of them, even all but very quick trackdays. Good...
Fly by wire... no reset needed. If you have a touch of throttle on, then the ecu will see it.
I was chatting with a customer last night about whether a smaller one would follow.... A 600 would be ace. World Supersport would be opened up...
The increase in pressure is because the gearbox isn't being unloaded. Could be the sensor is failing, but as it's irregular and no errors are...
The "logic" in the QS relies on the throttle being fully shut. If you're trying a open throttle shift, then you'll need to clutch it. Even partial...
Yep. You need the reverse shift rod and then turn the crank round on the gearbox selector shaft. The shift rod is a DP part. It's currently...
Why would you not tighten a safety critical part up to specified torque? You can’t rely on the safety clips, they are there to help, but if the...
@Shazaam! how you doing Larry. Been a long time
I have a DP seat kit to remove lights etc. Be plain white. £85 Also got a couple of the DP/Corse race sump kits to fit inside the fairing, removes...
Ducati list a flat time of 2 hours for the oil/annual service. Same as the V2's, so you don't pay for the time to allow the oil to correct itself....
Not 2.5hrs to warm up, it’s takes that time for all the oil to return to the sump when the motor is turned off and give an accurate level reading....
Just had a look and yes, they are in the parts list. 69710351A @ £3.47. Looks to cover all the DVT's inc. the 1260's. Not Enduro though.
Honestly don't know. Haven't seen one for the DVT. I use a steel rule and as the bikes are at chest height on the bench, it's not such a problem...
Pm me the vin and engine numbers and I can check it for you. Doesn’t look like a SPS. Ecu wouldn’t fit under a be seat, even if the subframe had...
They look like they've already been "fixed" once before. The 748 shouldn't/doesn't have plates in there.
