Separate names with a comma.
I do like the Sigma stuff. Have used it for years and always get good support from Neil Spalding on set up. There's been some good deals around on...
Pretty good. Up there with the best of what's on the market. basket and plates tend to last well, 48T is quieter and more positive on engagement....
@chrisw can help you with that more than I. I'm fortunate enough to have access to the factory diags.
It's not a blue thing, but getting the owners manual out is a good start. Once you get the basics, then asking for specifics is easier and the...
Should be tapped. If you have to pull the cover, whilst it's not good marking the case, the seal is in the bore via 2 o-rings. I've seen some...
Sounds like the ECU is not seeing the throttle open. As you changed the TPS, have you reset it? If so, use diag software to take a look at...
They can be a PITA at best of times. Worth a try ;)
That's a 1.6M ECU.
Sorry. The pictures on the parts fiche are just line drawings. The part number against the '97 bike is used on 916 94-96, 916SP, 916SPS '97-'98...
Sorry, I don't have one kicking around. Asked around but no luck either...
I'd be happy to fit it for you on our shock press, but it's a bit of a trek. Have you tried Kais suspension in Atherton? it's a 5 minute job with...
I more than agree, but putting a bit of perspective on it can alleviate those concerns sometimes. I'm not saying there's not an issue, and I know...
There's a lot of chat about this already. Brembo have issue the recall. That will need to be filtered through the manufacturers, then out to...
There's only limited parts info available as of yet, so doubtful your dealer can tell you either. Give a week or so and I can check again, but at...
Have you tried holding the key next to the antenna at the base of the screen? The antenna loop can activate the key in the same way it used to on...
No, you don't have clearance for the bigger pulleys. Monster 620, 750 and 900 from around 2004 used them also iirc
They're bigger and wider.... Different belts to desmoquattro. You can use the vernier pulleys off the later 900 2v engines.
853 motor is a sweet tune. 748 feel and revs with 916 torque and power. You can bore the 748 barrels and get them replated. Deck height is wrong...
The machine mart ones are pretty good for home and don't cost the earth. They available from elsewhere and sometimes better money. Think they all...
Not sure if I have one TBH. I can take a look next week when I get back in the workshop. Hens teeth springs to mind. Not sure if they're available...
