Separate names with a comma.
I have the factory DDS unit, but there is some freeware out there to do this. @chrisw should be able to advise? The tough one is a decent CO...
There should be stops on the bottom yoke. 10mm locknut and a 3mm allen key iirc.
Thanks for the mention Birdie and thanks for the replies :) It was a very special moment and a big honour. It's the only award that I can qualify...
Technically.....if a problem arose with the motor then it could be disputed. If it was a chassis issue for instance then all would be fine.
Written directly to ECU bradders.
Rexxer use euro spec bikes at their base in Germany. The DVT has took some cracking as it uses a new Bosch ECU. Now they've gotten in there, it...
Don't have a bike to hand, but not had the problem before. I've had several of them out to date with no issues. It's a bit fiddly and obviously...
Most are M6 screws so 9Nm
I'm a big fan of the CTek chargers. Whatever you go for, they usually come with the lead included.
If you're just wanting to get the sprocket cover off, pull the slave cylinder, undo the quickshifter and you're in. You can get the plate out that...
Had a 796 with this. The battery terminals were loose. The retaining strap hadn't been fitted at PDI and the battery can rock back and forth,...
They're available from your dealer. Get quite a few breakages. It looks like the heat from the lamp makes the plastic brittle :(
Yep, fairings and headlight fairing all look to share the same part numbers
It was a few years back now tbh. £800 rings a bell... They're really quite helpful, so I'd drop them a mail. If the exchange rates are good then...
I got a ETI fuel-cel tank for my 1098 and it was easily the best thing I did to the bike. 100 miles was easily doable. Had a few close calls with...
Just an aside from stack height etc. Have you bled the clutch up?? Might have been "adequate" with a worn pack in there, but if you're not getting...
You defo need a friction plate in first. Just build with alternate types and finish with a steel. If you can't measure the stack, you want about...
They're not sandcast but the 1198 went over to the new tech vacuum casting process. They're lighter as a result. The R's got sand cast ones...
The chrome may possibly clean up with a polish. New seals and fresh oil would then sort the leaks out. You have one of the best dealers on your...
