Separate names with a comma.
I've seen them run on 996 belts before, even when you could still buy the RS items.... Iirc, the cam pulleys are narrower than the R though? Might...
Yellow ;) They're faster!
Take the cap off and you'll see a small hex headed screw. That's the bleed screw for the cylinder. Loosen it a half turn, pull the lever and lock...
They are not the same..... Dimensions/teeth may be the same, but construction and tooth profile differ. Gates manufacture the belts for Ducati...
Not worth the risk. For a few quid, it could cost you your motor. Use Ducati or Exactfit
The ECU controls/switches a few components and does it by switching the earth, not the positive. Components like coils, injectors, fuel pump etc....
Iirc, the earth is off a common in the loom. Before you go chasing wiring, just drop a meter across the connector (loom side) and see if you get...
Is the earth good to the ignition circuit? There's a single 2 pole connector on the rhs of the airbox that feeds the ignition coils, ignition...
The cover is also held in place by some rubber grommets along the rear/top edge. Prise the cover away and you'll be there. Just keep an eye on the...
No Wayne, that is miles.. The second bike has been very good. The first had a few warranty claims, mostly corrosion problems as the bike was...
I had a customer crack 32k on his first Pani and is now well over 18k on his second. Engines have been faultless.
Another thing worth checking is the multi connector on the lhs of the fairing. The connectors usually stay clean, but water can sit in the lower...
Not worth it. The PC can't fuel the lower rev range so relies on O2 emulators to fudge the signal. Rexxer tune is around half the money and...
You sure on that p/n? It's not a Ducati part number..... which 916 is it? Is it the large square units under the seat? There's 2 types if so, one...
They're also different shades/colours depending on red, yellow paintwork ;)
Agree with Steve... Pretty sure they were at best maybe a dealer paint job special. Seen a couple of 916's in the past that were both painted by...
The belt doesn't look to be a OEM belt. Also the tensioner bearings and idler bearings don't look stock?? Have they been swapped out? Smaller...
Cornerspeed Is on there :)
Very rare. I'd take a look at the whole rear assembly and check it's all secure. The sprocket carrier nut can loosen and cause play to be felt in...
Ducati and Termi have got a 'classic' collection going again. Got a set in the workshop ;) they are ie ones though. They're not doing carby...
