Separate names with a comma.
BikeTrac is a great piece of kit. Big benefit is that the bike is protected when you're away from home as well as when it's tucked away in the...
The blocking of the air bleed Chris mentioned is so the exhaust gases can be read accurately without being diluted by fresh air. To the OP..... If...
Yep, different pitch. 40mm use stock 1.5mm pitch and the later caliper uses 1.25
A Ducati belt says Gates on it to Steve ;) Pic 2 shows two different belts. The teeth have a different finish, particularly to the side of the...
The infamous Renault timing belt ;) Look at the picture comparing the two belts. The lower one with the red reinforcing running thru it is a...
John's right. Only a fiver each ;) any dealer can supply
Gasket is 79010211A. The O2 plugs are part of a "small parts kit" so don't come up on the parts list as a number. You can get them off eBay. M18...
Ducati warranty stays with the bike. First two years, plus the extended year if it's Ducati's one. There's a slip in one of the owners manuals,...
You need 9's in there. My regular service plug is the DCPR9E for the ST2. Works just fine without forking out on iridiums
JC.... Had a look this morning and it's just silencer kits they're doing. The list is... Carbon silencers 45mm 748-916-996 Carbon silencers 45mm...
Not if I recall. The list is pretty much all silencer kits. The 749/999 would probably have the decat'd link pipe. I'll check tomorrow :)
The kits are being re released by via Ducati Performance. A lot are being supplied with ecu except the monsters iirc. No EPROM is being supplied...
Look on page two..... There's a big radiator on the wall ;) it's a proper man den that one. There's a huge beer fridge as well :)
There's three wires from the stand, but only two on the loom side connector. Just bridge those and it's sorted. The LA Stone 749's were prep'd a...
You can effect a small amount of vacuum adjustment/balance by using the air bleed screws in the throttle bodies. I wouldn't play around with the...
Brembo Serie ORO discs and Bendix MF pads work very well. Good money to ;)
The throttles are set and sealed on assembly. You don't need to touch any part of them. Balance, TPS etc. are all set and covered in tamperproof...
The reflash that Dave had is done using the RexXer system. Done on site with a dyno run before and after is £285 inc. VAT. The postal service is...
GPR do half decent silencers for the ST's. Fitted a couple of sets and they go on quite well. Good money to
