Separate names with a comma.
The ring isn't available separately. Had a few with the same issues. The clamp is spot welded to the silencer as it has a hook that locates the...
Your warranty is valid at any dealer in the UK, or Europe for that matter.
Your not that far from me. Just up the a38 at Sutton. If you want to get your own tyre then I'm happy to fit it for you on a labour only basis....
From your post, you have the pazzo levers fitted. Before looking at plate issues, check that there is sufficient free play at the master cylinder....
Cleaners that claim to be non acidic tend to be alkaline, and in most cases very. Muc off is a classic case. Ph' of 11 or higher have been...
As above, a good long run will help but another tip is to disconnect the hose from the breather at the back of the rear cylinder, leave the bike...
Mar10's are the correct plugs. I've seen conventional plugs used but even so, the 8's are way out on the heat rating.
I can't understand why there'd be a need to short the side stand switch other than if it was knackered. The 848 will start with stand down. A...
Battery could be goosed... They don't seem to like being on a charger continuously, especially the "gel" type. I do a lot of batteries this time...
The impact to the gear lever could have knocked the selector out of alignment. Is the gear change positive? Possible false neutrals? If you move...
There are two pipes that run from the cap. Breather and overflow. Both are routed internally to the pump base. The come out of the pump base and...
The rubber is bonded to the metal "washer/thread" unit. Use a pair of grips, grab the washer part and undo it. If it's proper tight, and it may...
That is correct. The cases go back on with Threebond sealant. Contact @Exige on here as he's setting up to bring CA Cycleworks parts over and they...
Yep, the torque charts are sometimes a little wayward imo. For me, a stock M6 screw has a DIN standard of 9-10Nm. Other factors come into play...
The number I have for the M6 bleed nipple is 4Nm... The 12Nm figure is for the bigger one used on the radial cylinders (M10 I think), rear...
Have you checked the nut on the sprocket carrier? The bearings are pretty reliable.
The 'spigot' on the RS tanks I referred to is a separate pipe outlet for a pipe to run from with a non return valve in line. It's completey...
That's the overflow hole and seal. If its a genuine RS or a copy of one, then they were designed to work with a secondary breather valve off a...
Heat shield looks to be missing the correct fibre washers and spacers. They insulate the carbon from the heat. The screw and flat washer...
They were all covered by a single bulletin over here. Looks like that is the yanks going all Hollywood on it. That was issued a while back now....
