Separate names with a comma.
The guards on their own are only about 15 quid each. I've seen a few different alternatives fitted but none have really worked IMO even to point...
Watch out also for the small copper sealing washer on one of the mounting screws Matt. It's worth putting a bit of sealant on the thread of that...
I use a couple of them in the work shop, and a rule of thumb is if the bike has the later 55mm nuts/6 bolt carrier then it works. Fitting a...
You need to change the eprom as you are now only firing one injector, hence half the fuel. Try a 916 open pipe eprom, the Senna chip was banded...
180/55 every time. The 190 section tyres need a 6" rim as mentioned. The 55 profile can also give clearance issues around the exhaust/swingarm...
190/55....the 50 is too low and will really screw the TC up. as already mentioned, the Rosso Corsa or BT016 Pro's work really well.
Ditto on EvoTech. I'd take it over the R&G anyday. Top quality and decent prices
BT016 Pros. Good prices to
Sodding iPads :rolleyes:
More or less...... You'll need to remove the locating pegs on the switch gear and throttle housing as the Renthals are drilled.
I really rate them. Used on my 1098 and they worked great and wore well. The Pro is better and although now replaced, they offer great VFM.
Dont think pin diameters are changed etc. but development is. The pistons are getting lighter, oil control improving, materials need to hold up...
HYM piston is completely new Ant...it's a 4V so needs 2 more valve pockets ;) 848 cases were completely new to. They were the first to use the...
Stamped into RHS of headstock and on a silver sticker LHS of headstock (usually easiest one to read)
Is it when you select first at a standstill? Sounds like the clutch is dragging. Try it with the clutch lever at maximum span. If that improves...
Thanks. It's hard to get the pictures to do it justice. The white and black are both pearl colours, so the sunlight just pops them. The silver on...
[ATTACH] Just completed this for a customer :upyeah: [ATTACH]
Also, when you've torqued the axle, give the adjusters a tweak so they are hard up against the blocks and lock them off. Even with the axle tight,...
