Separate names with a comma.
Yes Bob. Picked up on a thread a while back, made some enquiries, and now have access to to them from Afam.
I have afam ones in stock. £25. 01623 238944
RHS of mudguard where the brake line runs thru it
be worth giving Bike Torque Racing or Mode performance a call. Both Brembo importers
You need to get it plugged in somewhere and see what's happening when it cuts. Many moons ago I had a SPS that ran fine until it got to about 80...
The moment it cuts, open the fuel cap. If you get a whoosh of air, then the breathers are blocked
If you get the light on permanently, rather than key off push the mode switch up and you should get an error code displayed on the dash. That at...
EvoTech do a nice tail tidy for about £95. Speedymoto do a decent range of sliders for the frame and axles.
Might be worth checking the tank breathers. Doesn't sound electrical tbh as it started up on the button. There's a single pipe connected to base...
When the light comes on, are you getting a misfire? The ignition relays are notorious for giving up the coil errors. For a few quid, it's worth...
No restriction, but it's probably had the new fuel map flashed in during service. Does make quite a difference :) Enjoy
Technically, you're right. It's showing a white light to the rear and should fail. My tester would fail.......Not sure if it breaks use and...
14 will work a treat. I wouldn't go to a 13, even if you could find one, as the chain will start to wear the slider out on the swingarm.
In short...Yes. If you've tried bleeding it to no avail, could be the seals in the master cylinder. Have you replaced the levers at all?
there's no hard and fast rule, but if the master has significant air in it, then bleeding the slave is either slow, or never happens. It's...
Which multi is it? If there's a bleed nipple on the master cylinder, bleed from there before the slave. If not, wrap a rag around the banjo on the...
I had a service job last week that had had the plug rounded out. I used an Irwin 14mm stud extractor on it. Tap it on and it tightens as you undo...
The reed valve is the crucial bit. Many of them ignore the prime function of the valve and just go for bling. If you fit a straight thru one, you...
New ones are just shy of £29. No coding to do, just plug n play. Check also the connector just down the RHS of the ignition barrel. Could be...
Could still be the key antenna Tom. Take a look at the antenna moulding and sometime you can see the green corrosion just peaking thru the...
