Separate names with a comma.
A take off the coil signal would be easiest. That's where I pick up for dyno work. As mentioned, there's a whole load of CANBUS going off on the...
30Nm +/-5..
Is it trying to click up into neutral when at a standstill??? If so, the clutch needs bleeding. Also, if you have the clutch lever quite close to...
Converted my 748 years ago and was well happy. Fitted with a Brembo radial master and they're as good as my 1098 was. Pads from Brembo are pricey,...
Don't think so. Take a look on the back of the old pads if you still have them. There should be a Brembo part number and there's usually a HH...
The stock pads are sintered. I'm with Pict on the EBC stuff tbh. My favourites are Bendix MF pads. Performance Friction are also very good.
Don't have the handbook to hand, but the schedules I have show brake and clutch at 36 months?? Only Panigale is excepted and that's 24 months.
848 Street fighter runs the 11 degree engine and is 5 years on belts or 15k miles. 1098 is 2 years. Had to double check as I had some conflicting...
Brake and clutch are 3 years. The new coolant from Agip is 4 years..
1098 is still 2 years or 15k..... I think (it's late) that the 848 streetfighter is the same as MTS and Diavel because of the 11 degree heads....
Can't see you having any issues at all running the 14T front tbh. Give it a try and see how it goes. If it works, then think about switching to...
Don't have much experience of the diag program, but depending which ECU you are using will mean whether the trim function is actually available....
180 deg F is only 82 deg C :upyeah:
Sounds like your reading Fahrenheit so 180 is around normal running temp. Fan will cut in about 210 or so iirc
You'll defo need a good puller, but as an aside.....leave the nut on the end of the crank. When it does go, it goes big time and if there's...
They very rarely, if ever match. Don't worry 'bout it.
Got a couple of sets left...bit of a deal on them to. Drop me a pm if you're interested.
Should be 11mm. If it's been swapped out, it may be imperial as many hydraulic fittings still are... If it's still weeping, you may have some dirt...
I know have some of these in stock. Afam, so good quality. £24 inc. VAT
If you can, make a draw bar. Get some hefty threaded rod that will go thru the pivot. Nut on the RHS side making sure its smaller than the od of...
