Separate names with a comma.
Immobiliser only. Bike Trac unit is approved by Ducati and at the moment, there's a free unit with a new bike and ducati insurance are doing 25%...
Think the head angle is the same. The longer headstock makes a small difference to the trail I think....
Install height on the 1098 is same for Ohlins as well as Showa. The original 848 forks may well be different though Bradders?? The front ends are...
1098 forks are fitted with 242mm from top edge of lower yoke to top of fork leg. This gives about 2.5 rings above top yoke iirc. 848 is...
There's no key data stored against the VIN. Can get blanks, but you need something to copy from. rather than take the ignition barrel out, try and...
OEM....not the cheapest option but it takes the guess work out of diganosing a problem should one still be present....
The tester will only report on certain conditions like live short or earth short. You can also use the tester to look at "live" data being...
Maybe Baines checked and they were within tolerance and left alone? The clearances involved are tiny....0.05 on a closer is OK. Wouldn't take much...
Pass on my regards if ya would Jon. Been around the Ducati scene for many years and is well thought of.
I've used Shell and Motul fully synths in wet clutch bikes with no problems. Road and DD. I know some of the DD lads had trouble with the Shell...
The 600's seem to be favourites for cracking the half rings tbh. Very rarely see 4V fail. You can reduce it by filing the ends of the half rings...
A little.... Both the stem and/or shim can be affected. the stem can usually be dressed back. The shims sometimes don't fit on the dowel when...
Al, there's usually little or no wear on the shims. Because they are being directly acted on by the follower in a linear fashion rather than...
No worries Chris. I follow what you're saying. The closing spring will act on the closing shim and pull the valve in to the seat as tight as it...
Have a talk to them Peo...... Its old fashioned but still the best way :upyeah: Bear in mind it needs to be cold to do belts and valves so it'll...
Sam and Pete at SPR are a good pair of blokes and know ducatis well. Tbh, taking the plastics off is minutes on the 999 and if they're in place...
You can get drag on the opener Chris. Its much less common though. Two scenarios........openers opening up and closers tightening.... Mainly due...
The MRR are very good, but too focused for road use. I'd consider them a track only pad.
Bendix MF compound is good for fast road/trackday. Decent money to
There was a tech bulletin on the lock and software on the earlier bikes. Might be worth checking with your dealer if your bike was affected and...
