Separate names with a comma.
Depends why you want a bike. They are very different those two - one is a jewel of early 2000’s engineering, the other is a blinged up standard 1199.
This is sold - nice little track bike that is super rare…...
I fitted a Brembo RCS19 radial master cylinder to my 916. Calipers were 748R 4 pad axial type. Worked really well.
That’s a fairly big question. The brake will fit if you have: - correct fork bottoms - if you aren’t fitting new bottoms to the forks you have,...
Many 1098Rs were used as track bikes, mine included. Not necessarily a bad thing as they are usually very well maintained and over-serviced.
Growling 70mm system…....
This one?...
According to this, 1098R side stand is P/N 556.1.046.2AB...
That appears to be a 748/9*6 type alloy stand. 1098 stand is steel, mine is black/dark grey colour. Perhaps see if it is magnetic, if not,...
These are quite good. Except….the video for 749 says that after tensioning horizontal belt, one should turn the crank backwards by 90deg to put...
Is the horizontal cylinder at TDC on the compression stroke? Have you got a workshop manual or looked at any YouTube guides?
There appears to be a full compliment of springs in that photo.
Whipped the LH fairing off my road 749R to install a NOCO flylead. Noticed the LH fairing well where it joins at the bottom was full of coolant....
You could remove one of each and measure them?
There’s a small bracket on each side to attach the rear of the fairing. They may be shown attached to engine (LHS) and rear brake bracket (RHS). I...
Rory Simpson from Simpson Mechanique? Met him at the Ducati Club de France 25ieme Anniversaire at Val de Vienne around 2000. What a piss up that was!
Looks like that subframe may have been whacked at some point in its life.
Tricky getting tyres for that.
8 years ago.
No, not mine. I already have two...
