Separate names with a comma.
OK, I sure someone will correct me but from what I know Vapour blasting (aqua blasting) is done with water and can have various media, plastic,...
Comfysofa, Basically the Outer and stanchions are bent, there seems to be a bit of a crease in the outers which could be a problem, but inners...
Hi My mate enquired at Brooks Suspension they said (and this is possibley confirmed by the parts diagram on the Triumph website) that the outer...
higgy748 - Thanks Rushjob - Thanks Will pass on info Cheers Gaz
HCP rings a bell. My mate is near them and think he has called for new prices. Will ask him to ask about straighening but I think the outer is...
In other threads I've been messing with a Ohline front fork. To be honest it's off a Triumph Speed Triple 1050R (so if it's not allowed on here...
Messing about with some bent Ohline Front Forks. Cartridge Service Tool. Made this from a Kids Scooter (Blindside 360 if anyone is intrested)...
Sinank, Just woundered if you managed to get these dimensions, I am after the same for a mate who has Speed triple 1050R Cheers Gaz
If you are talking 900SS I think it this, but please check sizes before purchase. 52 od 26 id 15 thk taper roller beaing Skf 639174 If you have an...
SKF or Timken Cheers Gaz
Countcoupe, If you can I would try and think about the first measurements for setting the suspension up, especially the rear. I am no expert (so...
Sorry Roadtrip, it's usually me that misses out, I do feel bad if that's any consolation. Cheers Gaz
Can I have first dibs. Will pm you. Cheers Gaz
Just something if anyone could comment on. When I did take it out, the charge light was flickering for the first 10-15 mins, I thought something...
OK, here goes. In my exitement and rush to get the bike back together, wait for it, I put the stator in the wrong way round, there I said it. I...
Just had a few problems with my charging system - entirely self inflicted, it's a bit embarrasing but I will up date my reno thread so others may...
Not sure if I should start a new thread (or not). Regards previously meantioned embarrassing breakdown and bump start in front of tutting audience...
Gurth, Looks like Desmo sorted you, but just wondered if you got the files. Cheers Gaz
1st of May, with tax done I was all set for the first run, I was supremely confident. You can already see where this is going. I had checked the...
I measured this up a number of years ago and have a .dxf file. I supplied someone the .dxf file for them to get it cut out but did not here...
