Separate names with a comma.
Just putting a few things back together. The rear Caliper does not seem to have an o-ring to seal the 2 halves - is this correct, I am sure it...
[ATTACH] [ATTACH] Cheers Gaz
Job, I will be honest I think it needs to be locked up. There is a thread from a while ago I will find it. 900ss Rear Shock. Search rear shock...
Jon, Shank length needs to be somewhere between 31/32 and 39/40 or the nut will bottom out on thread before it is tight. Cheers Gaz
Jon, [ATTACH] M10 coarse is 1.5 pitch. Grade was 8.8 but 12.9 could be what you find more readily. Shank is 9.9 dia Hole 10.20 - 10.25 I plan to...
Sad news. I didn't meet Al but shared a few posts, I thank him for his generous input. My condolences to his loved ones, RIP Al.
No problem - good luck. Cheers Gaz
What about something from Japan or USA and paying import duty & VAT? What about these: [ATTACH] [ATTACH] Cheers Gaz
gdbd59, I think there is another place, just got some float bowl screws from them....
Got mine from here. https://www.allensperformance.co.uk/ And https://litetek.co/ I know you might be puy off by Thialand but I did not have any...
Tedjeparre, thanks a lot synchro screw. [ATTACH] Bit of a pig to install. Cheers Gaz
[ATTACH] I dimantled the carbs years ago, cleaned them and they have been sat in a box. I have just put them back together and I found 2 springs...
I did see these a while ago, it was the cover for the bottom bearing that caught my eye. I think on the same web site you can buy the covers so I...
Desmo, I agree I don't think it is possible to get the 2nu03EC without damage especially the blind one. Yes Not looking forward to swing arm but...
Desmo thanks for reply. I am a bit annoyed with myself really. I have put this off, a bit unsure of the method and not trusting my ability. In the...
Just to keep information together I thought I would update this thread. So, I never got the blanking plates done as they were going to be too over...
The Pliers were no good, got the other retaining ring out the same way. I think the trick was was grinding a diamond shape the fitted snugly into...
Looks like there is a bit of wiggle room. Bore at bottom and seal and bearing layout above. [ATTACH] Cheers Gaz
I've got a dwg / .dxf of the rocker are tool if anyone what's one to get lazer cut. Thinking back it was a lot easier than the OEM Ducati tool I...
Yes, seen some of these during internet search thanks. I found some with notches in but they seem to start at 28 Diameter and above. I'll have a...
