Separate names with a comma.
Some folks tape up the holes in the handguards that allow to the lever reach adjusters. This blocks off a lot of the wind.
Open the nipple, pull the lever, tighten the nipple, release the lever, repeat as necessary. No need for a one way valve.
There is no up-map for the 2010-12 bikes, it's an ECU swap. I've idea what the later bikes say at power up.
So every time you plug it in and switch on the map is swapped between the stick and the ECU?
If you re-fit the standard exhaust how do you down-stick it again?
The filter screen unscrews. Use the same 14mm allen key that used for the cover.
I mounted them on an alloy bar fitted under the beak putting them in a similar position to the factory ones. This picture doesn't do them justice,...
I fitted a pair of these 2PCS 125W Motorcycle Motorbike CREE U5 LED Driving Head Spot Light Headlight | eBay [IMG] I made my own brackets and...
I guess so ;)
Sorry, but I disagree. From the guide you posted - "Not Recommended Fuels with a high aromatic content; aromatic hydrocarbons (benzene)..." I...
I think you might find that a 2mm cross section is slightly too thick and that it jams and tears when you try to fit the connector. The ones...
The o-rings are size 011, 7.65mm ID x 1.78mm cross-section. You can buy them here at 14p each but you might need to buy an awful lot to make up an...
I got 10 of them from Ducati Glasgow for about a pound or two. They are a common size o-ring made from viton to stand up to petrol. I can check...
Faster valve opening speeds that conventional valve gear. Much reduced frictional losses in the valve gear. Compare turning a desmo camshaft...
It's not.
The pump flange is just held in with a few nuts, it may need a new o-ring when re-fitting but probably not, but you will need to get ALL the fuel...
Just leave it where it is and get it out at the next service when the fuel filter is replaced, it won't do any harm. The pump intake has a fine...
To be honest I have no idea why the manufacturer specifies the gap at 0.6mm nor if it has any effect on emissions. As you say, you'd expect a more...
Ah! UpNorth. I didn't realise you were a member. :) I think Sev has answered your question about OEM gaps. With regard to the quiet clutch, I...
If you look at the your quote from Shaazam again you'll see what he means about the gap size and voltage. With "stick" coils there are no plug...
