Separate names with a comma.
Cheers mate! :-)
Hi and welcome to the forum. Nice introduction and write up on your new bike. Not sure if it’s the angle of the photo but it makes it look like...
Fitted a titanium through bolt with locknut and also thought it wise to add the Spider support as per @Spence’s recommendation. Job jobbed! If...
Merry Christmas all!
Cheers Glen. Same to you!
Thanks @Spence, nasty one that! I knew the front mounting bolt had been upgraded a while ago, is there anyway of knowing if this has been done on...
seen a couple done that way. It makes sense.
Cheers lads. Looks like a possible mod is to fit a Ti bolt all the way through and a flanged nut on t’other end.
Tolerance of 5%.
Maybe mate. Not the first owner but only 3K miles and two years old. Who knows... Problem is finding another M14 x 1.25 x 40mm now the dealerships...
Not sure if it’s a mistake or what. I’d have thought about 30 with a bit of thread lock and job’s a good un. I greased under the head too...
Cheers Phil. I wanted to grease the pivot sleeve. I didn’t think it could have been 60Nm but the manual says so. It’s the only M14 bolt I could...
Must have been in a past life! :joy:
Only for the impact wrench on the slot I dremeled in! :joy:
Haha, wouldn’t be my first but my first in a long time. :) Not sure there was a previous crack. Are you referring ring to the slot I dremeled in...
Evening all. Just installing a TTX rear shock. Got it all back together but sheared that torx bolt. Managed to get it out so just need another...
Have a word with Steve mate. Bayliss boy had his 1098R in a bubble jobby in his garage for ages.
Spent all day yesterday pulling off the 959 exhaust and fitting the 1199 system. Ball ache of a job to get to the manifold bolts but not too bad...
Lucky! Our roads haven’t been dry enough for weeks now.
Now sorted. Thanks
