Separate names with a comma.
Showa forks will fit (Ohlins models need a larger, 56mm bottom yoke). AFAIK the brake offset should be the same but, you'd probably need the...
749 front wheel doesn't have the fitting for a speedo drive and I doubt it would be possible to machine it as you'd lose all the bearing housing?...
I used 'slic-tite' which is a fuel resistant paste but I think it's basically PTFE? Whatever it is, it hasn't leaked...
Best wishes for a full & quick recovery.
It will provide the correct torque if the spanner is at 90 degrees to the torque wrench. However If used in a straight line, as per the pic, you...
Don't know, presumably (if the rubber is the same thickness) slicks might weigh more than treaded tyres? I fitted a new Diablo Rosso III rear...
I have similar from QB carbon. They are larger than the standard and I cut out the openings in the fairings a little to suit. I did originally...
When I've tried that I usually end up dropping the clip into the engine whilst attempting to fit it, that or it 'pings' across the room. Plus...
Likewise, a real wheelie machine but the handlebars used to 'swivel' in the clamp and I broke one of the frame rails (the 'swingarm' tube) through...
I have a pdf of Ducati workshop manual for 1999, 996. At 20mb it's probably too large to email but I can upload it for you to download if you're...
I use a length of 0.4mm shim steel and a large jubilee clip. With a little oil, tighten it up to get the rings in the grooves and then back it off...
Agreed, for what it's worth on standard bolts (especially stainless) I normally use copper grease and on hi-load stuff like these pinchbolts, rear...
5 Minutes to get this on just using my hands; [IMG] 5 minutes later; [IMG] I wish the Guzzi tyres had been so easy; without a doubt the worst,...
I've had to go out to look at it as I've never removed the bracket but there are 4 fixing bolts; the 2 posts that the light unit pushes onto are...
[img]
I had the fuse holder (the larger of the 2 underseat) melt, it was actually still working but the whole thing including the fuse was a glob of...
To add, I used to get tyres supplied/fitted by a tyre specialist/bike shop until cheap tyres on the 'net became available, then I would use a...
Many of those are too small to fit a 17" wheel properly. I tried 2 different models and the support rings were a smaller diameter than the rim so...
Friend of mine bought an early 916SP, official import from a UK dealer and it had Kmh speedo. I think Ducati just used what stock they had/could...
Now sold, thanks.
