Separate names with a comma.
The temp above the engine of a full fairing 4 valve is often more than 90 deg in traffic so it should laugh at 70 deg.
0000 is fine like candy floss
Hi Boots, I would use 0000 grade wire wool and GT 85. You're only looking to break the top sheen so it does not reflect directly any more. You...
Yes, it is a non - Desmo.
Sorry Air Duck, no offence intended. It seemed you thought I was looking to replace the plug in-situ and implying I was worried about something I...
Thanks DQ. I've got one on its way, just wondered if anyone had managed it or found a different route. Just peering in to the strainer housing...
All very interesting, I'm sure, but not that helpful in answering what I thought was a relatively straightforward question: Can anyone confirm...
It's not about fixing it without splitting the cases - and you're right; that isn't possible. It's about checking it without stripping it. I...
Please has anyone here managed to actually get a view of the crank oil gallery plug inside a desmodue with the top end of the engine still...
Polyethylene in not recommended for long term storage of acetone, in particular thin walled LDPE with a large surface area, which those cans look...
They have had the rear return section removed so acting as straight through essentially unbaffled pipes. Combined with the carbs and open airbox...
Does the stuff on the screen stick to the magnet?
I would not say that the symptoms you describe are typical of a gallery plug backing out. Before pulling it apart I would do a compression test...
Hi all, I'm looking for a pair of standard wheels suitable for a late model 900 SSie please. Cosmetics / bearing condition etc. unimportant but...
I would check the spring rate before trying anything else - it could be that it's a spring rated for rider plus pillion, which would feel much...
I get any Arai vents, replacement pads etc that I need from Motostorm in Italy. Wide range of parts includng those Arai dealers over here won't...
I have, and I'm not.
You can see the gallery plug without endoscopes or mirrors. (though a torch will help!) Just look down horiz cylinder port at the crank in the...
It it were mine I would give the bores the lightest possible hone to help the rings bed in properly and be sure of a good oil film and good...
The crack is just starting but definitely better to catch now before it grows. There is a lot of force put through the headstock under hard...
