Separate names with a comma.
If you are using a new nut then you will have to resort to restraint and torque wrench gws. :upyeah:
[IMG]
It's up to you re: starter sprag noise - you could put a video/Youtube video up? I wouldn't go dismantling the starter unless you have a strong...
re: undoing nut, if you can buy or get access to one of these:-...
The picture below shows the rotary oil seal used on many Ducati gearchange shaft, it's installed in the crankcase "side capping casting". however,...
you are right, all concentration is needed and always have to make slight allowance for air-loss. I've used a digital one in the past which is a...
When you've identified the exciter boxes, (next to coils in your picture) you can follow the two braided wires on each box down to the crankcase...
"the kokusans" are the "exciter boxes" adjacent to the the coils marked BB1105 on them as std. Kokusan is the manufacturer..
How can we find out if we have 100-year-old on this forum? It would be pretty special and particularly if he or she rode a motorbike!
The sound you describe sounds more like the starter clutch than the starter motor, you might be able to differentiate with a screwdriver or...
here's a pretty bad one:- [MEDIA] [MEDIA]
Standard set-up nearly always have a plastic "dowel" in moulded switch and corresponding hole in handlebars but there were some exceptions. If...
go down the pub?
If you are happy with all fueling checks (you know about the small "O" ring that is revealed when the black plastic diaphragm cover is removed?)...
@Ducbird
?? that's why it gets complicated on a Forum.. The shimming suggested by hypermotbloke was to sort out endfloat on a hub apparently. I can't see...
[ATTACH] [ATTACH]
did you detect any movement from Keith Richards?
controversial time again, although sideplay/movement shouldn't exist between rubberised cush-drive outer shoulder and rear sprocket, they nearly...
