Separate names with a comma.
The keys are linked to the immobiliser on your clocks. Replacement clocks would need to be virginised, if that's possible and programmed to accept...
Good point Shed. The S4 had a separate immobiliser, the same as the ST4s but for the S4R it moved to inside the clocks. So water ingress could...
Since the fuel pump primes it's not the relays. If there is no spark and no injection it is most likely the the crank sensor that has packed up....
There was a change to the cylinder head design around about 2001/2002. If your bike has 5 screws securing the rocker shaft end cover (16 in this...
I hadn't seen your reply on the other thread Chris. Didn't realise there was another one but not surprised.
I suspect that it does need to be hollow. It is directly below the jet needle, the tip of which may go down into the bolt when the throttle is...
He also says "I also soaked everything in this rust remover with hot water for a good few hours first. They need to be completely clean before...
He purchased a kit off eBay. The original listing is long gone but this is the same one which, after a bit of research, he decided was the best on...
I'll ask my son for details about the kit he used.
You can buy kits to do passivated zinc plating yourself. My son used one when restoring his 916 Strada with excellent results.
When I got my bevel 900SS I bought an L.S. Starret 0-2.00" micrometer. It came complete with a calibration piece to check it against. It cost 30...
If you can get them I always had the best results with DCPR8EA-9 they are pre-gapped to 0.9mm.
Termi supply a sleeve thing to fit on the end of the cable where it normally attaches to the butterfly but you'd be better to fit the Healtech...
No video required. Just remove the cable, the butterfly defaults to the open position, and unplug/remove the servo motor and fit a Health ES-DO2...
Mine was made in Bologna, but those for the far eastern and some other markets are made, or possibly just assembled, in Thailand.
It's not stainless. Either an alloy or plated steel. I'd need to check and I doubt if it is easily removable. I suspect that the ball is moulded...
I've been bit unwell for the past 6 days or so, not Covid fortunately, and didn't really feel like going out to the garage. However I went out...
Yes, it's a 30 fuse mounted above the starter solenoid in front of the battery. It protects the regulator in the event of a reversed connection...
Glad to help. If you look behind the steering head at the RH side, tucked under the front of the tank you will fine a small white connector like...
I use one of these on my Supersport, replacing one of the handlebar fixing bolts. They are available in M10 but the internal hex is smaller than...
