Separate names with a comma.
Back from a 3 week holiday in NZ. Finished the external junction box. The momentary switch means I can reset the fuel usage to zero whenever I...
You can run an adaptor lead connected to your OBD connection under the seat into the cubby compartment under your rear seat pad. That way you...
Spent a few hours yesterday afternoon, soldering and insulating the seven wires that go from the external junction box to the heater and...
Air duct adaptor plates back from powder coating. [ATTACH] Initial mock-up of the new 15 litre tank completed. I have yet to add the inline fuel...
I did in fact. I just included a link so that others could watch it. :upyeah:
U$S59,000 for a road going complete bike. Looks great on the video and US$28,000 for the engine. Considering they are handmade not that expensive...
Hope you had a great day Ducbird!!
Couldn't resist a small mod. Realised that placing the Stahlbus bleeders on the inside of the front calipers as per the position of the original...
Just waiting on some silicone custom laser cut gaskets for the heater outlet ducts (silicone rubber is ideal at withstanding typical outlet...
Finished adding heat shield panels to the "hot end" of the flight case. Fuel pump installed and fitted the first of the modified through-hull...
These are the heat outlet ducts I had made up by a local fabrication company. Outlet hot air temperatures can reach up to 110C, so you cannot use...
Nice! Yes I have bought from them over the years as well, mostly titanium rear wheel nuts. Great price and quality.
When dealing with diesel heaters, the fuel pump is a dosage pump, so rather than run continuously, it pulses and delivers the fuel in metred...
Several metres of wiring removed and this is the end result. The main plug is to the heater ECU and the smaller plug is for the fuel pump. Where...
Time to continue "butchering" the flight case, to accept the new 3d parts. First up was marking out and drilling the holes for the power inlet,...
Interesting build. Surprised at the amount of corrosion on a relatively new bike, such as the purge line clips under the airbox, though these are...
The heater being located outside would not fair well to exposure to the elements, since they are primarily designed to be fitted inside...
So it's been a while. I've finished all the wiring in the enclosure and have now moved onto the heater build (more on that to follow) First up was...
Not the easiest of things to solder accurately, but this is how the LED board looks now. You can also see the new cable I made up, each wire being...
I was lucky enough to have private health insurance through my employer, as I ended up having two separate cervical disctectomies for C3 AND C6...
