Separate names with a comma.
It is the same as my 907ie but I'd need to take the fairing off to find out. If it doesn't start just swap the connectors round.
I can see that this bike is going to better than new :)
My local bike shop keeps it. Here is an ebay listing for it...
All my Ducatis with hydraulic clutches have done this. I used to think it was contaminant from the seals because over the winter while the bike...
I posted about this in another forum thread last year. On my 2017 Supersport I used heatshrink to the same effect. Since I already had various...
Basic wiring diagram as promised: [ATTACH]
I doubt it. It's a 9-5 Aero and there is hardly room to squeeze a slip of paper in there but removing the headlight requires; unclip and remove...
I have a 9-5, it is easiest to remove the headlight. It only takes a couple of minutes. Fortunately they are HID and don't need changing very often.
It will depend on the bike as some models have a relay for one of the beams already, or a relay before the dip switch which not so good as the...
Good point. Too much rebound damping can cause the forks to ratchet down if they are being compressed again quicker than they can recover.
After all this time I can't remember the figures for the the 900SS but the Pantah 500 manual says 5mm deflection at the fixed roller with a load...
Something isn't right. Maybe you should have your dealer check it.
Is your bike a base model or an S? I have a base model with the Marzocchi forks. With the factory preload setting a cable tie was moving down to...
I can't remember. I'll have to look and see.
Ok. If the bike is cranking it is unlikely to be the solenoid nor starter nor battery connections but could be connection elsewhere. If a relay is...
I had a 2 sets of these (all 4 bulbs) on my 2010 MTS1200 and they were brilliant (no pun intended) with a good cut-off on the dip beam. They were...
Can you explain this a bit further? Turns over! Does that mean the starter is turning the engine? Clicks! What clicks? If the starter solenoid...
When I first got a 900SS with cam belts back in 2000 I used a spring balance to set the tension. I just used a bit of bent fence wire to hook...
As long as there isn't an alarm or tracker slowly draining it.
Is there a Bosch equivalent that will fit in the same rubber mounting sleeve?
