Separate names with a comma.
I used an Abba stand on my Multi but with a separate front stand for the front wheel. I don't see that there should be an issue using the front...
It hasn't happened yet and I sincerely hope it doesn't.
Make one from a bit of plastic or metal of a suitable diameter. It's about 4mm dia and 4mm long. Best to make it slightly long then fine tune it...
Very :)
Reflector.
Bugger! I moved the bike just now and found that the bottom yoke touches lamp fan housings on full lock and knocks them askew in their mounts. I...
The handbook says that the headlight bulbs are H1 for the main beam and H7 for the dip. It is rubbish, they are both H11 and I have just replaced...
I now have a replacement for the Multi : [IMG] A new Supersport 939 collected from Ducati Glasgow yesterday. 110 miles so far and loving it [IMG]
To my mind the black makes it look heavier.
Yes, look what became of Aermacchi :(
The indicator warning light has 2 wires going to it, a white/black from the LH side and a white/green from the RH side. You will need to cut both...
Something like 1N4001 or 1N4002 or similar, around 50V 1A should be ok. You should find something in Maplins.
I have seem similar problems when all indicators are changed to LED. The warning lamp in the dash is a filament bulb, usually 1.2w, and is wired...
Looks like they're made from a couple of coke cans!
I have changed the oil on many Ducatis and find that they never take more than 3 litres to fill to the maximum line. The total capacity varies...
Good news. I was wondering how you were getting on. Did you have to do much? I'd have thought a change of oil, clean out the carbs and a new...
Yes, and pay particular attention to the in-tank fuel hoses. These can degrade badly if immersed in old petrol for a long time.
Why bother with an HPI check? If it's bent it's bent. Do an alignment check.
Don't try to take it apart, you will almost certainly break it. The contacts make a sliding contact so pressing harder doesn't work. Remove the...
The wheel alignment is easily checked with a laser. You can make a tool with one of the cheap laser levels. Not much you can do about it if it is...
