Separate names with a comma.
So it is. Must pay attention :dizzy:
If you are using JPdiag, Scan5MX or TuneECU I think you are wasting your time. These are all intended for use with Marelli ECUs, the Panigale uses...
Which ST2? The early single phase or the later 3 phase?
You'll have to wait until I get back from Turkey in about 12 days
So was Duckhams 20w50 :D
Good to hear it :)
Yes somethings not right there. That is a helluva mess for a "recently serviced" engine. I'd be wondering why the pulley nuts are hammered....
2 different amendments at £30 each. If I had been putting the Supersport on immediately or within a few days it would have been £30 but it will be...
Maybe, but that is only for 9 months cover. It will renew next April, I'll see what happens then.
In the RH beak, just beside the radiator cap.
Until yesterday I had 4 bikes on a policy with Ducati Insurance (Ramasis), the Multi 1200, the Scrambler Classic, the 907ie and my Pantah 500SL on...
Have you had the beak off? You have to unplug the air temp sensor to remove it. Maybe you forgot to plug it back in?
Bearing Part No. : 70250621A They are 25mm x 47mm x 12mm, NSK 6005DDUC3
[IMG] [IMG] [IMG]
Good. Chris will sort you out. :upyeah:
It is the black connector you should be looking at. Pins 10 and 38 are the outside corners that would lie towards the outer edge of the ECU. Like...
No but you need to disconnect the black Engine connector. It's the one on the right of this picture. There is a tab on the bottom that needs to be...
The S model has better suspension and some other, mainly cosmetic changes but I think the map is just the same. Although I could be wrong.
A Punto ECU won't work. Some of the internal hardware is different apparently.
As Fin says and bearing in mind that this started off with wires being nipped, are you getting continuity from the ECU connector to the coil? This...
