Separate names with a comma.
The pedal is made of aluminium alloy. I didn't weld it myself but got it done at a local ladder manufacturer who do loads of alloy welding. I...
Today I took the heads off. It doesn't look too bad in there although there is evidence of mild contact between the pistons and inlet valves which...
Got the alloy adjuster blocks out of the swinging arm. No heat needed. After soaking in WD40 since Monday I was able to draw them out using the...
The dash controls the headlight. So if the dash goes off so does the headlight.
Agreed, but the previous coaters obviously weren't, the frame numbers are barely legible. Another coating like that and be gone.
That had occurred to me Pete. I've going to have it stripped back before re-coating but I'll clean up the frame number before hand and instruct...
I did consider heat and may resort to that since I'll be getting the swinging arm re-coated, but thought that perhaps the alloy would expand more...
It's registered 1/10/1982 and has only done 29,600 km, about 18,400 miles and I'm happy that every thing is there and not too scabby. The original...
The ECUs on all fuel injected Ducatis adjust for cold starts. The fuelling is adjusted according to the outputs from the air and engine...
That sounds like a good idea. I'll see what I can rig up. Thanks.
As I mentioned in the other thread last week I was picking up a dismantled 500SL last weekend. Well I got the bits and have had time to do an...
Depends how bad it's got. If you catch it early enough before the cementite process has properly got going you can scrub it off with emery but...
Yes, that correct.
Quite possibly it's due to cementite build up. This can occur when the brake is held on to a hot disc and pad material burns into the surface. It...
I'll try to explain. The centre tap connection (red wire) is connected to ground, so that makes the negative connection. The 2 yellow wires are...
The O-ring should sit on the lip near the top of the tank flange spigot. Make sure it is properly in place and grease the tank aperture before...
Since it seems that it's not actually going into a gear but the light is going out then the problem is likely to be the neutral switch being...
I've no idea. I haven't seen it yet. So do I. I'll be sure to let you know.
The 3 wire alternators are not actually 3-phase, they are single-phase with a centre tapped winding. This picture will give you an idea of the set...
The 1098 manual, which I'd expect to be the same, says nothing about how many times the nuts nor the studs can be used. The nuts, washers and...
