Separate names with a comma.
I posted about an issue with a Shorai on a 1098 a couple of months ago but didn't get much response. Any of you guys got any thoughts on it?
I did give you duff gen but I now see that your engine is an 1100 but an earlier one. This pic is from the parts manual for a 2008/9 HYP1100 and...
I think I've given you duff gen on that part. It's for the 1100 engine and is in fact the exh cover but looking at your pic I think you might have...
There is an o-ring but you should be able to reuse it
I think it's this bit you need (24 in the picture) [ATTACH] It's the inlet valve cover, part no. 240.2.041.1A
Any chance of another dealer, or at least a service centre, in Scotland north of the central belt? A 200+ mile round trip for a service is no...
I'm surprised El Toro hasn't posted about this yet. Italia-independent [IMG]
I swapped them over on mine. Once the OEM levers were off I can't remember having any particular difficulty in removing the cylinder and pin.
I took a Tee off the GPS connector under the LH side of the tank.
I have a set of these on my bike. They are fecking bright and until I adjusted them to tilt downwards so that their aim was within the dipped beam...
That's what I said it was in the first place :rolleyes:
I'm fairly sure that they are an Amphenol Military Spec connector. Could be this: 62GB-56T08-33SN Amphenol | Amphenol 62GB-56T08-33SN, 3 Way Cable...
It would need two switch faults before the starter wouldn't work with the bike in neutral and the neutral light probably wouldn't work either. The...
This is correct. The ECU will only allow the starter to operate if: The bike is in neutral The bike is in gear with the stand up and the clutch...
There are 2 wires to the solenoid connector, a red which should be live with 12V all the time the ignition is on and a grey/green that the ECU...
My ST4s came with one of theses K&N filters. When the time came to change it it wouldn't shift and the nut on the bottom just tore from the...
With this kind of result - [IMG]
I'm not sure that they are, but if so you should still be able to measure a voltage across the contacts of the open circuit grip but not the one...
Quite bit in here. And at least a few people have replaced the Ducati grips with aftermarket grips or heating pads.
I've never measured the voltage but the resistance of the grips on my MTS is 7.5Ω but they are 10.5Ω on my Scrambler. I'd expect the voltage to be...
