Separate names with a comma.
I was going to fit a pair last week but the rear 190/55 size isn't available in the UK right now, so I've just gone for PR3s again.
The part nos. are available in the downloadable parts list from Ducati.com RH panel : 69916571A, LH panel : 69916581A
I posted about this in the ST section recently. Oil pressure sensor is same as Vauxhall Agila/Meriva. Coolant sensor is same as 1.2 8V fiat Punto.
I did the quiet clutch mod at about 5,000 miles on my ST4s. The original pack lasted 38,000 miles and the basket and drum had barely a mark on...
Good to hear you got it sorted :upyeah:
Best to get it checked out. It may be coolant from a leaking head gasket or a porous head casting but is more likely leakage from the hose from...
You should be able to clean that up using one of these. Once you have the board cleaned up and any joints re-soldered it's a good idea to lacquer...
PM sent.
Recently I rode to Glasgow and back on a tankful. A 191 mile round trip. The LCD said I had 7 miles of fuel left, the tank took 19 litres! So the...
I found the post I was referring to. You can see it here. It's reckoned it has something to do with the gearchange. The screw is also fitted to...
I have no idea but there was some mention of it and similar consequences mentioned on ducati.ms a while back. Whatever it is, it is only fitted to...
Not sure what you're seeing there in the pic, but I guess that some of the soldering is looking a bit dodgy?
They are all the same.
The fact that the revcounter drops to zero indicates that it is an electrical issue, nothing to do with the fuel supply. I'd suggest that it is a...
I stuck mine on with superglue when I got them. It bonds the rubber to the metal and they will (hopefully) never come off.
Mine is fine, no marks at all. Looking at I can see how the position of the banjo at the caliper will affect the lie of the brake hose and the...
For my 2010 1200 ABS, I have the hard copy 913.7.170.1A and the downloaded pdf 913.7.170.1B and it's not mentioned in any of them!
Not in the 2010 owner's manual.
I'd think that the throttle side grip from most replacement sets would fit. You'd need to buy 2 sets but still far less than £150.
Yes, but you have to take your eye too far from the road for my liking.
