Separate names with a comma.
It’s the needle bearing that sits in the end of the gearbox shaft, not the push rod cap. As Ricky said, remove the small seal in the shaft (if...
C is for "cam", M is for "motor". C is the timing pick up located to the left of the water pump (same position as a single sensor engine) and the...
They’re all the same. If you’re running a very early pressure switch, with a spade terminal (doubtful on a 99) it will supercede to the later...
Make sure the adaptor is M10 x 1mm pitch.
The bike is in RACE mode. That disables rear ABS and warns that front only is active. What you have is stock display for that mode. There's also a...
28mm front, 46mm rear and 41mm for the sprocket carrier
Front should go in ok with 5mm spacers in the caliper mounts. Rear will be fine as is.
It’s an led off an old datatool alarm. Popular place to fit them back in the day
Agreed. Fitting the crank is the easy bit, but making everything else fit and work is the issue. PM me the details of the bike/year and i'll see...
More than likely not, or at least straight forward. Type of alternator etc. 2 and 3 phase gennies have different rotor mountings. But the piston...
Inspection/clean at 9k and replace at 18k. You’d see a hike in labour over an annual if it had been done as the tank has to be removed.
You can do it on the bike, but it will need the 9v feed. When you turn the ignition on, the fuel injection system is only energised for a short...
As Loz said, if it's the USB version are you using the 9V battery to power the PC up? If not, it'll switch off as soon as the fuel pump cuts as...
Not sure about the construction rules, but don’t under estimate the weight of a couple of bikes and “stuff”. Most bike weights are dry, with no...
If you struggle getting a diag tool, you can go ‘old school’. Tbh, I still do it with out diag. The error reporting is crude at best. If you’re...
The clear sheet goes over the separate parts of the tank pad to keep all the sections aligned once they’ve been pulled off the backing sheet.
Sounds like the new plates have pushed the pack thickness out too much. With the pack assembled on to the drum, before you put the pressure plate...
M8 x 25mm iirc.
List is £4270 inc. VAT. Fitting IS a 'mare of a job. A day is a fair guess. Like Andy mentions, the software upload needs to be activated by the...
Wouldn’t say so. The old connection allows ingress of water into the coil stick and usually shows up as a short. You can try sealing it up, if it...
