Separate names with a comma.
Yep. You need the reverse shift rod and then turn the crank round on the gearbox selector shaft. The shift rod is a DP part. It's currently...
Why would you not tighten a safety critical part up to specified torque? You can’t rely on the safety clips, they are there to help, but if the...
@Shazaam! how you doing Larry. Been a long time
I have a DP seat kit to remove lights etc. Be plain white. £85 Also got a couple of the DP/Corse race sump kits to fit inside the fairing, removes...
Ducati list a flat time of 2 hours for the oil/annual service. Same as the V2's, so you don't pay for the time to allow the oil to correct itself....
Not 2.5hrs to warm up, it’s takes that time for all the oil to return to the sump when the motor is turned off and give an accurate level reading....
Just had a look and yes, they are in the parts list. 69710351A @ £3.47. Looks to cover all the DVT's inc. the 1260's. Not Enduro though.
Honestly don't know. Haven't seen one for the DVT. I use a steel rule and as the bikes are at chest height on the bench, it's not such a problem...
Pm me the vin and engine numbers and I can check it for you. Doesn’t look like a SPS. Ecu wouldn’t fit under a be seat, even if the subframe had...
They look like they've already been "fixed" once before. The 748 shouldn't/doesn't have plates in there.
All the best. Hope it goes well for you.
That's the "posh" part of Notts to..... I'm never going to be able to look some of my customers in the eye again LOL
On low torque screws, M4, M5 etc. used in fairings and the like, try a few wraps of plumbers PTFE tape on the threads, or a spot of silicon. It...
It's worth following the cable up from the QS and checking the connector is plugged in fully. They're a bitch to get at and the tab quite often...
Yep. Always stick to stock torque figures. While the screws/bolts may be able to take more, it's the assembly that dictates the torque values.
The recall is a new slave cylinder piston. It's termed a floating piston, so I guess it's better at aligning itself in the bore of the cylinder...
Just to be clear, it's 10Nm, not degrees. My info is straight off the factory manuals, but they are linked to my dealer account. The manuals I...
Is it a S or base model? The torques are in my first post.... Not all download manuals are correct, many are "drafts" that got copied and they are...
Is the bike a S or base? Ohlins forks use a M8 screw (6mm Allen key), they’re done up to 19nm. Base model forks use a M6 screw (5mm Allen key) and...
picture of bike.... [ATTACH]
