Separate names with a comma.
What Birdie said. Been an age old problem with that connector
Hi Gab. The error switches for the exhaust valve and O2 sensors are disabled in the software. The O2 sensors are unplugged and could be removed if...
Yep. They look correct. As mentioned above, the tighter tolerances are assembly and the second set are service values.
Service schedule is based on the annual anniversary of your registration/PDI date or mileage, whichever comes first.
Just the forks I'm afraid....
I have a mint set of 1198 ohlins that a customer has asked me to move on for him. If they're any use, let me know. £900 buys them.
2.2 bar front and 2.4 bar rear. That's the factory settings and I've run them for years without problems, regardless of tyre. Dropped a few psi...
As above, definitely your exhaust valve has seized closed. Just done a customers bike this week with the same problem.
Rexxer have a map for the 998 with full system in the library. Its also available with the limiter raised to 10800. I can do a postal service on...
Sounds like the spider spring has given up the ghost. Pull the pressure plate and take a look. They crack around the base of the fingers
It's a shallow top hat spacer. Just in there to stand the rod end off the mount. You can use a m6 Spring washer if you're stuck. Quite are few...
That's a helicoil alright, but one that's been screwed in too far and the tang has been left on. The bottom coil has closed in on the bottom of...
Tickover is controlled using the air bleed screws and the CO trim. Balance/set the tickover using the airscrews. Raise the tickover by turning the...
Throttle stop shouldn't be touched. It's preset to the angle the TPS is zero'd to. Move it and the return signals from the throttle won't...
M5 X 20
The spring caps shouldn't move at all. If they move outwards when the lever is pulled, then the clutch pushrod is pushing the whole drum assembly...
If the spring caps are hitting the cover, then check the clutch centre nut hasn't come adrift
Yeah, should be fine as Andy said. They're M10 so 42 is in spec.
Big wheel nut is 230Nm. Iirc, Cush drives are 30Nm, but not 100% on the latter
Your nearest dealer?
