Separate names with a comma.
If you're just wanting to get the sprocket cover off, pull the slave cylinder, undo the quickshifter and you're in. You can get the plate out that...
Had a 796 with this. The battery terminals were loose. The retaining strap hadn't been fitted at PDI and the battery can rock back and forth,...
They're available from your dealer. Get quite a few breakages. It looks like the heat from the lamp makes the plastic brittle :(
Yep, fairings and headlight fairing all look to share the same part numbers
It was a few years back now tbh. £800 rings a bell... They're really quite helpful, so I'd drop them a mail. If the exchange rates are good then...
I got a ETI fuel-cel tank for my 1098 and it was easily the best thing I did to the bike. 100 miles was easily doable. Had a few close calls with...
Just an aside from stack height etc. Have you bled the clutch up?? Might have been "adequate" with a worn pack in there, but if you're not getting...
You defo need a friction plate in first. Just build with alternate types and finish with a steel. If you can't measure the stack, you want about...
They're not sandcast but the 1198 went over to the new tech vacuum casting process. They're lighter as a result. The R's got sand cast ones...
The chrome may possibly clean up with a polish. New seals and fresh oil would then sort the leaks out. You have one of the best dealers on your...
2007 1098 is £115 new
That info is model designation. Looks right though. The VIN is the chassis number and starts with ZDM..... Can't get any info off the engine...
Can't do it off the reg I'm afraid. I need the last 6 numbers off the VIN.
If you drop me a pm with the VIN I can check it out for you and confirm if it's an original mono :)
Another thing just came to mind whilst fitting a set today..... get a good quality pressure gauge. I use a Clark inflator to pump the tyres up and...
Stick with stock pressures of 2.2bar front and 2.4bar in the rear. I ran the BT016's on my 1098 without any issues. I get a lot of bikes coming in...
Transfers are easier, and should be cheaper. Downside is you'll feel the edges. My painter always paints, even the lettering. When finished its...
I've been fitting quite a few Conti's to customer bikes of late. Different bikes and types of tyre. Nothing but positives. The Road Attack 2's...
The 45mm silencers are available new, with ECU. Part of the collection Ducati and Termi have put together for some of the older 'classic' ranges.
There were EPROMs around with raised limiters. I had the same software as Sigma but not the ability to burn fresh chips. Neil did a couple for me,...
