Separate names with a comma.
If your using the stock seat, the dda connector can be moved down to where the rear of the seat locates. Just need to lift the seat then.
I'd still check the carrier nut. I've seen them barely hand tight yet the clip has still been in place and tied up. If it is done up, then you're...
Thanks :) a few years back, I had a ST4 with a few issues. One it wouldn't rev past 4 or 5k, second it wasn't charging great and then it randomly...
Does sound like reg/rec is playing up, but I can't see why that would affect the high speed running.. When was the fuel filter changed? As they...
There should definitely be no movement in the wheel. When you say you can see movement on the hub, is that between the wheel and hub flange? If...
Button headed socket screws work well enough. M5 x 20. I'd get some nylon washers as per stock fitting though to save the paint.... Just finishes...
My interpretation is that all time based servicing is done from registration date. It has been for years and I've always advised my customers as...
The first service is 600 miles or 6 months. Then annually from registration.... With 1400 miles on its nothing major, a couple of hundred quid.
I've replaced a couple of chain sliders at around 15k. Going to 14T front will potentially increase the wear around the swing arm pivot area. If...
Yep, that's the stuff
The Ducati sealant is Threebond TB1215. I've used nothing that's worked as well.
The frames were never fitted with plugs, so you've probably some after market parts fitted in there. Do you have a picture? I have some plain...
Once a parts order is placed, it's trackable. The order status in the warehouse is, and once despatched from the warehouse, and DHL have it, you...
I've never come across any problems with the compatibility of STM, or any other basket being a problem. Probably fitted most combo's over the...
Possibly, but tbh I've never had to down that route. If it does tighten, I tap it back in and start again. They're the same/similar material so...
Just had a DB9 Brivido thru the workshop. Stunning to look at, brutal to ride. Diavel motor in something the weight of a monster with no rider...
Yep. Tap the screw heads. The thing has to come out dead square. You could fit the screws, turn it over with the screw heads on the bench and tap...
Take all the screws out of the flywheel. Looks like you're there. Fit three in from the back, equally spaced, with a few threads engaged then tap...
If you look at the assembly tolerances, it's bang on the money
Looking at you actual measurements, they are all in tolerance. You don't need to adjust any of them. Adjusting a closer, won't affect the opening...
