Separate names with a comma.
Sliders or not is always a debate. The thing with a lot of slider kits is how they are mounted. Looking at the Sato, I reckon there'd be...
Standard will be the assembly tolerances. Max will be service tolerances. I'd see where they are before thinking about changing. Even service...
Them there are the ones I have. Would do you fine :upyeah:
Had a look thru the catalogues this morning and Pirelli/Metzler don't seem to cover the 190/50 in any of the track tyres now. One supplier has...
Yep. be 'bout were Freak says. Like Andy says, depends on who and what dyno as well ;)
No impact socket will be made of ali....they are generally black finish and 6 point, but always steel. You'd be better off getting a quality steel...
If it is a 6" rim, then 190 is the correct width. A 180 will be stretched as you mentioned. If it part worns you're after then you'll struggle....
Yep. All the same group. Really good people with support etc. not just into selling you a box
Not sure. Could be silvery blue :rolleyes: Ordered one anyhow.... got too many nice ones in here over shadowing my 696 :tongue:
on its way
you got a mail address? I can mail you the parts diagram if it's any use?
Monster Art kit for Monster [ATTACH] [ATTACH]
Thanks. Appreciate that Kenoir :upyeah:
could be the case....never had it before but you may have say a 520 joining link with a 525 chain????
I always do near side first...furthest away from master. also, it's worth syringing the old fluid out of the reservoir first, the push the pads...
And it is again this year. Diavel is available in blue with the white stripe like the S4 monster....
keep hanging my nose over the Pantah monster art kit for the 696 :upyeah:
It should be ok then?? All I can suggest is to measure across the plates already assembled, and compare with your joining link. One other...
Have a check to see if the pins have been pushed back thru the rearmost plate during the pressing on of the outer one. It can happen if the recess...
76lbft rings a bell.... It's a very flat curve as well. A joy to ride :smile: chris Steadman at CJS did some nice heads that turned out similar...
