Separate names with a comma.
If there's enough meat on the hub to get a C spanner on and adjust, then you'll probably be ok with it. If you wanted to swap it out, have a scour...
The bike isn't due valve clearances til 7500 miles ie a Desmo service....... All you need is a 2 year service, maybe fluids as well. 400 quid or...
There's not a great deal to tell tbh. I've serviced several 696/796 and there's been very little problems. I've got a 696 of my own and it's a...
If filter has just been changed but was ok before, I'd check the pump over. Could be a loose fuel pipe of a split maybe.
The green glue is best used with acoustic plaster board rather than your regular B&Q type. It's much denser and is specially designed to supress...
It's possible without taking the servo off.....just. It's fiddly more than anything. The outer cable is clipped into the servo body. Use a long...
B&C Express in the UK are listing them Pedro. The part number you want is 462-520-37, wherever you get it from. The earlier 748/996 carrier is...
Rad wasn't a recall as such. Not all failed, only a few in relative terms, but if they did they were replaced under warranty. Can't recall much if...
If you pm me the VIN I can check it for you
Swap 'em. It's cheap insurance (relatively) and despite the turning to stop them taking shapes, the rubber perishes over time.
The gasket is not of a good design. It's very smooth where it seals against the head. Take the cover off and you'll see. Have a cloth ready as...
Those screws don't hold down the head. Just the valve cover. It's a common leaking point....... I always refit with a smear of threebond to the...
It's easier to unclip (twist and lift) the whole throttle trumpet/injector assembly from each throttle body, disconnect the fuel line and work on...
I've fitted a couple now for customers and had good feedback in both cases. Watch for duty and VAT on the imports. It'll add about 25% and they're...
I had a similar issue with a SPS quite a few years ago. Soon as the bike hit about 90 degrees it'd cut or at best drop to one cylinder. Checked...
749/999 come as complete unit. Twist and pull to remove..... as a guide, they are about 18 quid new.
Yeah, I think Jeff is off til new year. Drop him a mail via link on his website as he'll probably be monitoring that. If not, it's only a few days...
For a while my choice was Shell advance but its quite hard to get a hold of now. I've been using Motul factory line for a few years now and it's...
Yep, as above, go see Jeff at gtec. He'll get you sorted out
Where are you based Simon? I see in your profile midlands......
