Separate names with a comma.
Having moved into the digital age, all my manuals are now on USB sticks. I have about 30 odd genuine factory manuals, all in ring binders that I...
Have a few customers running them on 1098 848 etc. and have always ended up back at the stock settings. A big influence on them working well is to...
'bout a fiver iirc.
Pani is a little wider, but if you're thinkin front stand, then the DP stand that locates under the radial mounts works fine on both to.
No, I use DP or Guibellini and none lock into the axle.
Get a decent quality stand with a bearing mounted pin and it'll be safe as houses. Never had a faller.
Should do. 1098 was on 40mm pin by then :)
Yep. Works very well and longevity is much improved :)
Had a near identical scenario on a SPS a few years ago. It was the TPS unit suffering from heat soak and causing it to short out. Cooled the bike...
Make sure the rear wheel is aligned in the arm properly. The marks on the arm can't always be trusted so measuring from the swingarm pivot to axle...
Another bump after a failed purchase....
Probably ;)
SD motorcycles in Chesterfield have one that belonged to a good customer of mine.
Call your dealer....or make a list and mail it. Many of the original part numbers have been superseded and these don't show up on the 'net part...
Check the routing of the fast idle cable down the LHS of the headstock as Chris mentioned. There's a flat plate, for want of a better description,...
I supplied them :)
They're still available.. I fitted a set last week to a customers bike
Have those pulleys been off lately? The nuts look quite new. The pulley could have slipped off the key if it was dislodged as the pulley was...
Swapping over the relays might not be very conclusive.. They are in the same area and both suffer from corrosion problems. Fit new would be my...
Have you had the TPS reset following the ECU swap? 1098 should have lambda removed and mixture set up to.
