Separate names with a comma.
When I fit belts, to anything, I assemble them over tight and then turn the motor over 8 times. This gives the belts a chance to align on the...
It's fiddly rather than difficult. As said above take your time. There aren't that many screws etc. but there's some hidden "tangs" on the upper...
I've seen a few running the 180. I run one on my injected SS to. The hugger can be an issue, although not much of one. A bigger problem can be...
On the 999 you have a bleed screw in the reservoir. With the top off, you see a 6mm hex. Crack that half turn, pull the lever in, hold and lock...
Like the look of them. I'll take both pairs if I may :smile: could you mail me [email protected] with your details and how best to pay you?
Pretty sure none of the SPS ran the 1.6M....... Set up would be check and adjust TPS, balance throttle and set idle mixtures. Like Nelso says, you...
The SPS EPROM will be all wrong. It ran a P8 ECU with sequential injectors. Yours is on a 1.6M which fires both injectors together. JHP do decent...
Just checked what Andreas has said with the parts catalogues and he looks to be spot on. The subframes are the same. I know the helmet lock pin...
A TPS reset can help, but I've found having the balance and mixture set at the same time is a more successful solution. Lifting the tickover a...
I wouldn't touch the plunger, or at the very most only screw it in to the barrel. Screwing it out can/will cause the cylnder to pump up and...
I use Motul Factory Line lube. Very good and gives little fling whilst luring very well. Personally, the dry lubes are fine if you want zero mess,...
It's defo a new feature on the 2013 bikes. Not sure if it'll retro fit but gut feeling says probably. Ask deale rig he'll let you try??
There's no cable. It's a hydraulic system. Not masses of adjustment other than the span adjuster on the lever. The further the lever is out, the...
Tank off is my thinking. Can't think how you'd get it off without. Also the carbon one is goin to be much less flexible so if you could wrestle...
Nope. The 998 uses a complete loom for chassis and injection. Earlier bikes ran seperate looms with connections between the two. How bad is the...
should be fine. Look slike it's concentrate, rather than ready to pour, so mix with distilled water @ 50/50
I think QB are doing JHP's fairings Jon. Ian was into the moulds very early on after the introduction last year.
Defo sell monster privately. The two bikes are as different as chalk and cheese. Get a test ride and see if you think it's worth the swap. There...
Levering them out of the bucket without taking the bottom screw out :wink:
Watch the ones from Europe. LHD ;)
