Separate names with a comma.
@chrisw That circuit isn't quite right for many bikes including the ST2 and most Ducatis. The warning light is wired across the left and right...
Well it's not the ECU. At start up today I measured the battery at 14.3V, the ECU read 14.1V but the dash showed 14.8V. It reads a consistent 0.7V...
Thanks @chrisw and @nelly. I'll do a diagnostic and see what the ECU says first.
I'm wondering if anyone can through some light on a problem I'm having with a 1098R I'm working on. The dash consistently read BATT and shows...
I’m posting for a friend who is desperately looking for a mono subframe and matching seat/tail unit for a 2004 999s is there anything out there ?
I think the folding feature of the SS mirrors might have a lot to do with the blurry mirrors. On mine at any rate there is a few thou of free...
The bike is now sold.
I have seen 2 original stands fail at that top weld where it joins the pivot!
These bars are from a facelift ST4s of 2004/5 or from an ST3, which clamp direct to the fork leg below the top yoke. There is a pin that locates...
No chance, unless you drilled and tapped the SS top yoke. You might get away with fitting the ST top yoke as both the SS and ST use 50mm fork...
The seal is from inside the clutch end of the gearbox shaft. The push rod must have been pulled out from the clutch side and pulled the seal out...
The roads up here tend to get "top dressed" regularly. The roads dept sprays them with tar then spreads a thin layer of fine gravchips over it and...
Not really. Resistors are polarity independent, it will make no difference which way round they are connected although it is important that the...
I'm not aware of any internal pressure adjustment for the Scrambler clutch, although there is for the 936 engines of the Supersport, Hyper and...
BUMP.
I have no idea how you can possibly install a seperate flasher relay without seriously rewiring the flasher circuit. The switch connects to the...
You can buy 8mm shims from Lacey Ducati for half the price that Ducati sell them. Lacey get them made in the US, pity they don't do 7mm ones as well.
The stator windings will read very low, less than about 2Ω across the 2 yellow wires. You can also check that there is infinite resistance between...
Me too. :confused:
Here is a Ducati add from when the 907ie was introduced. Surely somebody has to be tempted :) [ATTACH]
