Separate names with a comma.
I think you are misunderstanding the desmo valve system @finm. They are actually much easier to turn over than a conventional valve spring set up...
The handbook for my 907ie says the belts should be changed at 12,000 miles but makes no mention of time. This is dating from the early 90's and it...
Is it a single phase or 3 phase motor? If you are not going for injection there could be difficulties in triggering an ignition system. I think...
It's not just the radiator, there is also the plumbing.
Melcodiag won't connect with the KKL cable, you need an ELM 327.
I think cleaning the lens would help.
SBS are my favourites. 566HS or 706HF depending on whether your bike has the earlier brakes with a single pad retaining pin or the later brakes...
Absolutely sure. The pushrod engages into the recess in the screw with its other end bearing against the piston.
No. If the screw is adjusted too far in the piston won't come right back so the bleed hole to the reservoir will remain covered. The fluid in the...
Funny you should bring that up today. I had an email this morning from a friend who has two triumphs, a Sprint and a 1200 Scrambler and he was...
I have never used a tig welder and OP's post looked like gobbledegook to me but from the replies I have learned something new. Keep it up guys...
I haven't got stick coils on any of my current bikes so I've no idea. When you get it out I'd glue it back on with a suitable glue. You might be...
Brilliant. So the ABS had effectively become disconnected from the bike. I should have thought of that.
I sold the Pantah last year - couldn't get on with the fit! But I did learn a lot about them. New belts, battery and oil and it should be fine. It...
No, it's not normal. It looks like the bottom has come off the stick coil and the spring which should locate on the terminal on the top of the...
CPS gap should be 0.7mm with the engine at the timing position. i.e. TDC on horiz cylinder, both valves closed. It is seldom the gap that is...
Well, that's a CPS failure state that I hadn't heard of before but the variety of types of failure of a CPS seems to be many and varied. It can be...
Agreed, and I considered that the problem might lie with the CPS. I have seen them fail when they get hot yet work fine when they are cold but...
OK. That suggests that there is a reduced voltage to the pump. The pump and the coils both get power from the fuel pump relay which could be...
Don't just throw it on the ground. Cats are particularly susceptible to it, they seem to like the taste. It is very poisonous even in small...
