Separate names with a comma.
Welcome, and congratulations! A fine choice. ;):upyeah: What number is yours?
Probably. Quite a few bolts that weren’t required. I would usually worry when I have parts left over but it’s definitely done correctly… The...
Done. Hopefully correct… seems to be working as far as I can tell but I’ll test tomorrow. Mine actually didn’t have the cover on that it said to...
Great instructions… They do not seem to match with the bolts provided… The instructions say to use 2 20mm bolts to fix the rearsets to the...
That’s not the issue - I know exactly where it was set to. The issue is that the nut would not tighten to torque after being loosened. It’s like...
Easy. :upyeah: There was a pin that had to be removed from the old part - one end of the sidestand spring goes on it - but a chain rivet tool...
So I loosened the bolt that holds the lever to the bit that the QS attaches to in order to see if sliding it along would provide sufficient...
After looking through the workshop manual for ages I’ve finally figured out that they are pretty much all 25nm. The fun part was that the various...
I found torque values for fitting the quickshifter, sidestand and rearsets to the holder, but I can’t seem to find anything for fitting the holder...
I’ve got some red Loctite stuff from doing bits on my car - is this suitable?
I need to fit a new hanger - the part that the quickshifter and side stand attach to. I’ve looked through the workshop manual but I’d appreciate...
:astonished:
If the rules were actually broken on those two previous years.
I'm still not entirely sure what went on. They were not allowed to use the stock carbon wheels, even though they had been used in previous years,...
I think to make the lever go higher I'd need to shorten the rod length (reverse shift), which would screw the rose joint further into the linkage...
Thanks @razz So it looks like there is a small amount of adjustment available without having to change the rod length and then changing the rod...
Thanks @razz and @nelly - that makes sense. Now I just need some guidance on adjusting the lever height... I'm still a bit confused about the...
I've got the Rizoma rear sets on my SP2 and had it changed almost immediately to race shift. They did this without using the linkage that is...
Not quite in the spirit of this thread, but I thought a certain person might like it. [ATTACH]
I’d like to think that the devil has a greater sense of style…
